Your first document
Write the smallest complete LaTeX document, give it a title block, and compile it to a PDF. Every document you write later has this same skeleton.
The smallest document
A document needs three lines around its text:
\documentclass{article}
\begin{document}
Hello, world.
\end{document}\documentclass says what kind of document this is. article suits papers, homework, and short reports. Everything between \begin{document} and \end{document} is printed. Anything after \end{document} is ignored.
Preamble and body
The lines between \documentclass and \begin{document} are the preamble. Settings go there: packages, the title, your own commands. Nothing in the preamble prints. The body is everything inside the document environment, and it is the only place text can go.
\documentclass[12pt]{article} % the kind of document, with one option
\usepackage{graphicx} % preamble: packages and settings
\title{A short report}
\begin{document} % the body starts here
Text that appears in the PDF.
\end{document}Options go in square brackets. Here 12pt raises the base font size from the default 10pt.
Text belongs in the body
If LaTeX finds a word, or even a stray character, before \begin{document}, it stops with Missing \begin{document}. When you see that error, look in the preamble for something that should not be there.
Add a title
\title, \author, and \date only store their text. \maketitle prints it, so it goes in the body, at the place the title should appear. The abstract environment adds a summary under the title.
\documentclass[12pt]{article}
\title{Tides of the Severn Estuary}
\author{Mira Okafor}
\date{March 2026}
\begin{document}
\maketitle
\begin{abstract}
We measured the tidal range at four sites over one lunar month.
\end{abstract}
\section{Introduction}
The Severn has one of the largest tidal ranges in the world. This report describes how we measured it.
\end{document}The title block has a few variations:
| Command | What it does |
|---|---|
\title{...} | Sets the title. Required before \maketitle. |
\author{A \and B} | Sets the authors. \and separates them. |
\date{...} | Sets the date as you type it. Leave the command out and LaTeX prints the day of the compile. |
\date{} | Prints no date. |
\today | The day of the compile, written out. |
\thanks{...} | Inside \title or \author: adds a footnote, often used for an affiliation. |
\today works anywhere in the body, not only in the title block:
This draft was compiled on \today.Compile it
In TeXeR, a new project already has a main.tex with a short article in it. Replace its contents with the document above, then click Recompile or press Ctrl + Enter. The PDF appears beside the source. To insert a fuller skeleton into an empty file instead, press Shift + Space in the editor and choose Article under Document.
On your own computer with TeX Live installed, save the file as main.tex and run:
pdflatex main.texThis writes main.pdf next to the source, along with main.log (everything LaTeX reported) and main.aux (notes LaTeX keeps for the next pass).
Common mistakes
- Text in the preamble. LaTeX stops with
Missing \begin{document}. Move the text below\begin{document}. \maketitlewithout\title. LaTeX stops withNo \title given. Add\titleto the preamble. Without\maketitle, there is no error, and no title either.- A missing
\end{document}. The compile ends withEmergency stopandjob aborted, no legal \end found. Check the last line of the file. - An unwanted date. Leaving out
\dateprints the date of the compile, which changes every day. Use\date{}for none, or type a fixed date.