# Spacing

> Spacing in LaTeX: lengths and units, horizontal and vertical space with \hspace and \vspace, line spacing, paragraph indent and skip, and stretchable space.

A lesson in Learn LaTeX (Layout, slides, and drawing), from TeXeR: https://texer.org/learn/spacing

Control the space between lines, paragraphs, and words, add exact gaps where you need them, and let stretchable space push content to the edges of a line or a page.

## Lengths and units

Every spacing command takes a length: a number followed by a unit. Use `em` and `ex` for space that should grow with the text, and absolute units for the page.

| Unit | Size |
| --- | --- |
| `pt` | A point, 1/72.27 inch. TeX's native unit |
| `mm`, `cm`, `in` | Millimetre, centimetre, inch |
| `em` | Roughly the width of an "M" in the current font |
| `ex` | Roughly the height of an "x" in the current font |

Some spacing is stored in named lengths such as `\parindent`. Change one with `\setlength`, or add to it with `\addtolength`.

## Horizontal space

`\hspace` inserts a gap of any width. The shorthands cover the common cases.

```latex
A\hspace{1cm}B\hspace{3em}C\par
A\,B \quad thin space (\verb|\,|)\par
A\enspace B \quad half an em (\verb|\enspace|)\par
A\quad B \quad one em (\verb|\quad|)\par
A\qquad B \quad two ems (\verb|\qquad|)
```

A `~` is a normal space where the line may not break, as in `Figure~3`. TeX drops `\hspace` at a line break. Use `\hspace*` for space that must survive there.

## Vertical space

`\vspace` adds space between paragraphs. `\smallskip`, `\medskip`, and `\bigskip` are fixed steps of about a quarter, a half, and a full line.

```latex
First paragraph.

\medskip
After a medskip.

\vspace{8mm}
After 8 mm.\\[4mm]
A new line 4 mm lower, in the same paragraph.
```

Use `\vspace` between paragraphs, not inside one: in the middle of a paragraph the space lands after the line the command happens to fall on. TeX discards `\vspace` at the top of a page, so write `\vspace*` there.

## Line spacing

The `setspace` package sets the line spacing of the whole document with `\onehalfspacing` or `\doublespacing` in the preamble, or any factor with `\setstretch`. Its `spacing` environment changes one passage.

```latex
\documentclass[varwidth=8cm, border=10pt]{standalone}
\usepackage{setspace}
\begin{document}
Single spacing is the default. Lines sit close together, as in a printed book.

\begin{spacing}{1.5}
One-and-a-half spacing, a common requirement for coursework and theses.
\end{spacing}

\begin{spacing}{2}
Double spacing leaves room for a marker's handwritten notes.
\end{spacing}
\end{document}
```

`setspace` keeps footnotes, captions, and tables single-spaced, which is what most style guides want. That is the reason to prefer it over the low-level `\linespread`.

## Paragraph indent and paragraph skip

LaTeX marks a new paragraph by indenting its first line by `\parindent`, with no extra space above. The other convention is no indent and a gap of `\parskip` between paragraphs. Pick one. Using both wastes space, and using neither hides the paragraph breaks.

```latex
\begin{minipage}[t]{4.6cm}
\setlength{\parindent}{1.5em}
Indented style. The first line of each paragraph steps in.

A second paragraph follows with no gap above it.
\end{minipage}\hspace{8mm}%
\begin{minipage}[t]{4.6cm}
\setlength{\parindent}{0pt}
\setlength{\parskip}{8pt}
Block style. Paragraphs start flush left.

A gap separates this paragraph from the last.
\end{minipage}
```

For block style in a whole document, load the `parskip` package instead of setting the lengths yourself. It also adjusts lists and the table of contents, which a bare `\setlength{\parskip}{…}` stretches apart. `\noindent` removes the indent from a single paragraph.

## Stretchable space

`\hfill` is a horizontal space that grows to fill the line, so it pushes whatever follows to the right edge. Two of them centre the middle item. `\dotfill` and `\hrulefill` fill the gap with dots or a rule.

```latex
\begin{minipage}{8cm}
Left\hfill Right\par
Left\hfill Centre\hfill Right\par
Chapter 1\dotfill 12\par
Signature: \hrulefill
\end{minipage}
```

`\vfill` does the same vertically: it pushes what follows to the bottom of the page, or of a box with a fixed height. When several fills compete, they share the space equally. `\stretch` gives one of them a larger share.

```latex
\fbox{\begin{minipage}[t][3cm]{3.4cm}
Top\par \vfill Bottom
\end{minipage}}
\fbox{\begin{minipage}[t][3cm]{3.4cm}
Top\par \vspace{\stretch{1}}
One third down\par \vspace{\stretch{2}}
Bottom
\end{minipage}}
```

A title page is the classic use: `\vfill` above and below the title block centres it between the top and bottom margins.

## Common mistakes

- Ending paragraphs with `\\` to get space between them. TeX reports "Underfull \hbox (badness 10000)" and the text is still one paragraph. Leave a blank line, and set `\parskip` or load `parskip` if you want a gap.
- Putting `\vspace` at the top of a page and seeing nothing. Space at a page break is discarded. Use `\vspace*`.
- Writing a length without a unit, as in `\vspace{10}`. TeX stops with "Illegal unit of measure (pt inserted)". Every length needs a unit, even zero: `0pt`.
- Stacking manual `\vspace` commands to make a page look right. The next edit moves everything. Fix spacing globally in the preamble first, and adjust single spots only in the final pass.

## Next

- [Paragraphs and line breaks](https://texer.org/learn/paragraphs-and-line-breaks)
- [Spacing in math](https://texer.org/learn/spacing-in-math)
- [Page layout](https://texer.org/learn/page-layout)
